Aviator AWD V8-4.6L DOHC VIN H (2003)
4. NOTE:
-
If reinstalling the original windshield, remove excess urethane adhesive from the windshield glass.
-
If installing a new windshield, clean the inside of the glass surface with an alcohol-free cleaner to make sure the ceramic-coated area is clean.
-
Wipe off the glass prep immediately after each application.
Apply Urethane Glass Prep Essex U-401 meeting Ford specification WSB-M5B280-C twice around the glass surface to be urethaned.
5. Apply Urethane Glass Prep Essex U-402 meeting Ford specification WSB-M2G314-B to the same area that was prepared in the previous step.
Allow five minutes to dry.
6. Cut the urethane applicator tip to specification.
7. Apply a bead of Urethane Adhesive Essex 400-HV meeting Ford specification WSB-M2G316-B, to the pinch weld just outside the foam dam.
8. Install the windshield glass by aligning it to the marks previously made.
9. After the windshield glass has set, check for water leaks and add urethane adhesive where needed.
