Continental V8-4.6L DOHC VIN V (1998)
Wheel Bearing: Service and Repair
REMOVAL
1. Turn the air suspension service switch off.
WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so can result in
unexpected inflation or deflation of the rear air springs, which can result in shifting of the vehicle during these operations.
2. Raise the vehicle on a hoist.
3. Remove the wheel and tire assembly.
4. Remove the front disc brake rotor.
5. Remove the front axle wheel hub retainer.
CAUTION: Discard the front axle wheel hub retainer. It is a torque prevailing design and cannot be reused.
6. Remove and discard the front suspension lower arm-to-ball joint nut.
NOTE: Make sure the steering column is in the unlocked position, and do not use a hammer to separate the ball joint from the front suspension
lower arm. Use extreme care not to damage the boot seal.