Mark LT 2WD V8-5.4L (2008)
Part 2
Disassembly and Assembly
All seats
1. Remove the rear seat cushion.
2. Remove the 4 rear seat LATCH bolts and LATCH.
-
To install, tighten to 6 Nm (53 lb-in).
3. Remove the 60/40 retention clip.
4. Remove the center support riser.
60 percent seat
5. Remove the 60 percent support riser bolt.
-
To install, tighten to 33 Nm (24 lb-ft).
6. Remove the 60 percent support riser pivot bolt and bushing.
-
To install, tighten to 33 Nm (24 lb-ft).
7. Remove the left support riser.
8. Remove the 60 percent seat cushion latch handle screw and handle.