Mark LT 2WD V8-5.4L (2008)
6. Remove the muffler and tailpipe assembly.
Installation
1. NOTE: Using an abrasive pad, clean the exhaust Torca(R) clamp surface area of any surface rust.
Position the muffler and tailpipe assembly.
2. Install the front muffler exhaust hanger bracket and isolator to the frame.
^
Tighten to 30 Nm (22 lb-ft).
3. Install the rear muffler exhaust hanger bracket and isolator to the frame.
^
Tighten to 30 Nm (22 lb-ft).
4. Install the tailpipe exhaust hanger bracket and isolator to the frame.
^
Tighten to 30 Nm (22 lb-ft).
