MKT FWD V6-3.7L (2010)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
NOTE: LH side shown, RH side similar.
Removal and Installation
1. NOTICE: Make sure to correctly route and secure the wheel speed sensor harness in the rear subframe assembly or damage to the
harness may occur.
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting. See: Maintenance/Vehicle
Lifting
2. Disconnect the wheel speed sensor electrical connector.
3. Detach the 2 wheel speed sensor pin-type retainers.
4. Detach the 2 wheel speed sensor harness retainers.
5. Remove the wheel speed sensor bolt.
-
To install, tighten to 15 Nm (133 lb-in).
6. Remove the wheel speed sensor.
7. To install, reverse the removal procedure.