MKT FWD V6-3.7L (2010)
Blind Spot Module: Service and Repair
Side Obstacle Detection (SOD) Module
NOTE: Left rear quarter panel shown, right side similar. Rear bumper cover removed for clarity.
Removal and Installation
1. NOTE: Module configuration is required when a new Side Obstacle Detection Control Module - Left (SOD-L) or Side Obstacle Detection Control
Module - Right (SOD-R) is being installed. Upload the SOD-L or the SOD-R module configuration information to the scan tool. For additional
information, refer to Programmable Module Installation (PMI) in Information Bus. See: Powertrain Management/Computers and Control
Systems/Information Bus/Testing and Inspection/Programming and Relearning/Programmable Module Installation (PMI)
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
3. Remove the 4 rear fender splash shield screws. For additional information, refer to Bumper.
4. Gently flex and pry away the rear bumper cover to access the SOD-L or the SOD-R.
-
Remove the screw and washer.
-
Disconnect the electrical connector.
5. Remove the SOD-L or the SOD-R.
6. If removing the bracket, remove the 2 screws and the bracket.
7. To install, reverse the removal procedure.
-
Download the SOD-L or the SOD-R configuration information. For additional information, refer to Information Bus.
-
NOTE: When enabling the Blind Spot Information System (BLIS(TM)) and Cross Traffic Alert (CTA) system make sure to enable the
systems in both the SOD-L and the SOD-R. Failure to do so will result in a mismatch system fault.
Verify in the programmable parameters that the BLIS(TM) and CTA system are enabled in the SOD-L and the SOD-R.
-
After the SOD-L or the SOD-R is configured, shift the selector lever though all the transaxle gear positions (PRNDL).