MKT FWD V6-3.7L (2010)
Installation
1. Route the TSS sensor wiring harness through the cover and the transaxle case.
2. Install the TSS sensor in the cover and install the bolt.
-
Tighten to 12 Nm (106 lb-in).
3. NOTE: If cleaning the main control assembly or inspecting the valves, refer to Automatic Transmission/Transaxle &/or Transmission Control
Systems. If installing a new main control assembly, continue with this procedure.
NOTE: Make sure that the manual pin (part of the TR sensor) is correctly installed in the manual valve.
Position the TSS, OSS and TR sensor wiring harnesses aside and install the main control valve body.
