MKX AWD V6-3.5L (2007)
Garage Door Opener Transmitter: Component Tests and General Diagnostics
Universal Transmitter Programming
UNIVERSAL TRANSMITTER PROGRAMMING
WARNING: A garage door opening system that cannot stop or reverse itself after detecting an object in its path does not meet current federal
safety standards. To decrease the risk of serious injury or death, do not use this universal transmitter with a door opening system that lacks
stop and reverse features as required by federal standards. This includes any garage door opening system manufactured before April 1, 1982.
Failure to follow these instructions may result in serious personal injury.
1. Verify the hand-held transmitter is operative.
2. Prepare for programming the universal transmitter by erasing all 3 channels by holding down the 2 outside buttons until the red indicator begins to
flash (20-30 seconds). Release both buttons.
3. Select 1 of the 3 universal transmitter channels to be programmed by pressing the desired button.
4. Hold the end of the hand-held transmitter 25-51 mm (1-2 in) from the front surface of the universal transmitter so that the red indicator can still be
seen.
5. NOTE: For Canadian vehicles only, during programming, the hand-held transmitter may automatically stop transmitting after 2 seconds, which
may not be long enough to program the universal transmitter. If programming this type of hand-held transmitter, continue to hold the button on the
universal transmitter while pressing the hand-held transmitter button every 2 seconds.
Use both hands to press the hand-held transmitter button and the desired button on the universal transmitter. Do not release either button.
6. Hold down both buttons until the red indicator on the universal transmitter flashes, first slowly and then rapidly. Release both buttons when the
rapid flashing begins. The universal transmitter has successfully learned the new frequency signal and can be used in place of the hand-held
transmitter(s).
7. To operate, simply press the appropriate button on the universal transmitter. The red indicator is on while the signal is being transmitted.
8. To program additional hand-held transmitters repeat Steps 3-6.
Training a Garage Door Opener Equipped With "Rolling Codes"
1. Program the hand-held transmitter to the universal transmitter.
2. Train the garage door opener receiver to recognize the universal transmitter.
1. Remove the cover panel from the garage door opener receiver.
2. Locate the training button on the garage door opener receiver. Location and color of the button may vary by garage door opener manufacturer.
Refer to the garage door opener instruction manual.
3. Press the training button on the garage door opener receiver for 1-2 seconds.
4. Press the programmed universal transmitter button for as long as the universal transmitter red indicator flashes (1-2 seconds). Release the
button and press the button to confirm that the universal transmitter is trained to the receiver.
5. The garage door opener should recognize the universal transmitter.
Erasing Channels
ERASING CHANNELS
1. NOTE: Individual channels cannot be erased, but can be reprogrammed using the procedures for programming.
To erase all three programmed channels, hold down the two outside buttons until the red indicator begins to flash (20-30 seconds). Release both
buttons.