MKX AWD V6-3.5L (2007)
Thermostat Housing: Service and Repair
Thermostat Housing
Material
Removal and Installation
1. Drain the cooling system.
2. Remove the air cleaner outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.
3. Disconnect the 5 coolant hoses from the thermostat housing and position them aside.
4. Remove the 3 thermostat housing bolts.
^
To install, tighten to 10 Nm (89 inch lbs).
5. CAUTION: Do not pull the other end of the coolant tube out of the engine block when separating the thermostat housing.