MKZ AWD V6-3.5L (2008)
6. Install the special tool between the power steering pump belt and pulley, turning the crankshaft bolt clockwise to remove the power steering belt.
Installation
1. Install the power steering belt on the crankshaft pulley.
2. NOTE: After installation, make sure the belt is correctly seated on the crankshaft and power steering pulleys.
Position the power steering belt around the special tool and the power steering pulley. Make sure the belt is engaged with the power steering pulley
and rotate the crankshaft clockwise to install the power steering belt.
3. Position the accessory drive belt on the crankshaft pulley.
4. NOTE: After installation, make sure the accessory drive belt is correctly seated on all pulleys.
Working from the top of the vehicle, using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner clockwise and install the
accessory drive belt on the generator pulley.
5. Install the RH splash shield and the 6 pin-type retainers (4 shown).
6. Position the RH fender splash shield and install the 4 screws.
