MKZ AWD V6-3.5L (2008)
3. Remove and discard the engine oil filter.
4. Remove the 2 bolts and the oil filter adapter.
^
Discard the gasket and O-ring seal.
^
Clean and inspect all sealing surfaces.
Installation
1. Using a new gasket and O-ring seal, install the oil filter adapter.
^
Tighten the large bolt to 57 Nm (42 lb-ft).
^
Tighten the small bolt to 10 Nm (89 lb-inch).
2. NOTE: Lubricate the engine oil filter gasket with clean engine oil prior to installing the oil filter.
Install a new engine oil filter.
^
Tighten to 5 Nm (44 lb-inch) and then rotate an additional 180 degrees.
3. If equipped, install the 6 screws and the underbody shield.
