MKZ AWD V6-3.5L (2008)
Install the LH VCT housing and the 3 bolts.
^
Tighten in the sequence shown to 10 Nm (89 lb-inch).
14. CAUTION: Make sure the dowels on the variable camshaft timing (VCT) housing are fully engaged in the cylinder head prior to
tightening the bolts. Failure to follow this process will result in severe engine damage.
Install the RH VCT housing and the 3 bolts.
^
Tighten in the sequence shown to 10 Nm (89 lb-inch).
15. NOTE: Lubricate the engine oil filter gasket with clean engine oil prior to installing the oil filter.
Install a new engine oil filter.
^
Tighten to 5 Nm (44 lb-inch) and then rotate an additional 180 degrees.
16. Install the engine front cover.
