MKZ AWD V6-3.5L (2008)
5. Pull out on the RH instrument panel trim panel releasing the 2 clips, then remove the RH instrument panel trim panel.
6. Through the glove compartment opening, remove the 2 passenger air bag module bolts.
7. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment doors. Damage to the air bag module
may occur.
Through the glove compartment opening, release the deployment door clips from the instrument panel and then remove the passenger air bag
module from the instrument panel.
8. NOTE: RH shown, LH similar.
Using a small screwdriver as shown, lift up and release the locking buttons on the passenger air bag module electrical connectors.
9. CAUTION: Do not pull the passenger air bag module electrical connectors out by the locking buttons. Damage to the locking buttons can
occur.
NOTE: RH shown, LH similar.
With the locking buttons released, remove the electrical connectors and the passenger air bag module.
Installation
1. CAUTION:
-
Do not install the passenger air bag module electrical connectors by the locking buttons. Damage to the locking buttons can occur.
-
The passenger air bag module electrical connector locking buttons must be in the released position when the connector is being
installed, or connector damage may occur.
-
The passenger air bag module electrical connectors are unique and cannot be reversed when connected to the passenger air bag
