Navigator 2WD V8-5.4L (2007)
Suspension Control Module: Service and Repair
Air Suspension Module
Removal and Installation
1. CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
Disconnect the battery ground cable.
2. NOTE: The air suspension control module is mounted to the lower left side of the dash above the parking brake control.
Disconnect the 2 air suspension control module electrical connectors.
3. Remove the air suspension control module nuts and the air suspension control module.
^
To install, tighten to 8 Nm (71 lb-in).
4. NOTE: The air suspension control module is calibrated with information from the ride height sensors. A new or exchanged air suspension control
module requires that the LH and RH ride height sensors are calibrated and a pneumatic test is carried out. For additional information, refer to
Vehicle Dynamic Suspension Calibration Initialize System - Clear C1990 and C1991 DTCs.
To install, reverse the removal procedure.