Navigator 2WD V8-5.4L DOHC VIN R (2001)
Removal
1. Remove the rear wheel disc brake adapter.
2. Remove the rear wheel disc brake shield.
1
Drill out the rivets.
2
Remove the rear wheel disc brake shield.
Installation
1. NOTE: Because the rear wheel disc brake shield is held in position by the four rear wheel disc brake adapter bolts, new rivets are not required.
Seal the rivet holes with Silicone Rubber D6AZ-19562-AA or equivalent meeting Ford specification ESB-M4G92-A, and install the rear wheel
disc brake shield.
2. Install the tear wheel disc brake adapter.