Navigator 4WD V8-5.4L (2010)
-
For the 7-pin connector, while applying the brake pedal, measure the voltage between the trailer tow C4099-1, circuit CAT06 (YE), harness side
and ground.
-
Is the voltage greater than 10 volts?
Yes
REMOVE the known good relay. INSTALL a new trailer tow turn relay. TEST the system for normal operation.
No
REMOVE the known good relay. GO to Z5.
-------------------------------------------------
Z5 CHECK FOR VOLTAGE TO THE LH STOP/TURN LAMP RELAY COIL
-
While applying the brake pedal, measure the voltage between the trailer tow LH turn relay pin 1, circuit CLS18 (GY/BN), BJB face side and
ground.
-
Is the voltage greater than 10 volts?
Yes
GO to Z6.
No
REPAIR circuit CLS18 (GY/BN) for an open. TEST the system for normal operation.
-------------------------------------------------
Z6 CHECK THE VOLTAGE SUPPLY CIRCUIT TO THE LH STOP/TURN LAMP RELAY
-
Measure the voltage between the trailer tow LH turn relay pin 3, circuit SBB45 (GY/RD), BJB face side and ground.
-
Is the voltage greater than 10 volts?
Yes
