Navigator 4WD V8-5.4L (2010)
Trim Panel: Service and Repair
A-Pillar Trim Panel
A-Pillar Trim Panel
Removal and Installation
1. Remove the 2 A-pillar assist handle bolt covers.
2. Remove the 2 A-pillar assist handle bolts.
-
To install, tighten to 5 Nm (44 lb-in).
3. NOTE: Carefully rotate the A-pillar trim panel during this step.
Remove the A-pillar trim panel.
-
Pull the A-pillar trim panel outward to release the A-pillar retaining clips.
4. NOTICE: To avoid damage to the A-pillar trim panel, remove any retaining clips from the body and attach them to the A-pillar trim
panel before installing.
To install, reverse the removal procedure.