Navigator 4WD V8-5.4L (2010)
5. Remove all hog rings.
6. Continue inverting and remove the backrest cover.
-
Route the safety belt webbing through the backrest cover opening.
7. Remove the 2 pin-type retainers and foam pad.
8. Remove the safety belt retractor foam cover.
9. Remove the 2 screws and safety belt retractor cover.
10. Remove the safety belt retractor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
11. Release the 2 tabs and detach the safety belt retractor guide.
12. Remove the safety belt retractor.
-
Route out the safety belt webbing, guide, tongue and anchor through the backrest frame.
-
Note safety belt routing for correct installation.
13. Release the pin-type retainer and detach the release cable from the backrest frame.
14. Remove the 2 screws, latch release handle and route out the cable.
-
Note cable routing for correct installation.
15. Remove the 2 pin-type retainers and 2 attaching straps.
16. Remove the 8 backrest support panel screws.
17. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To assemble, reverse the disassembly procedure.
Seat Backrest - Third Row, 40 Percent
Seat Backrest - Third Row, 40 Percent
Disassembly and Assembly
NOTE: For parts identification and locations, refer to Seat - Exploded View, Third Row See: Service and Repair/Rear Seat/Seat - Exploded View,
Third Row.
1. Remove the seat backrest cover. For additional information, refer to Seat Backrest Cover - Third Row See: Seat Cover/Service and Repair/Rear
Seat/Seat Backrest Cover - Third Row.
2. Remove the bolt and the safety belt buckle.
-
For installation, align the anti-rotation tab.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the nut, screw and support bracket.
4. Remove the 2 inboard latch-to-backrest frame bolts and the inboard latch.
-
To install, tighten to 40 Nm (30 lb-ft).