Navigator 4WD V8-5.4L (2010)
Parking Brake Cable: Procedures
Parking Brake Cable Tension Release
1. Remove the LH cowl side trim panel.
2. With the help of an assistant, release the parking brake cable tension by pulling down on the intermediate cable at the cable-to-cable union until
the parking brake control sector rotates to its stop and a 4 mm (0.15 in) x 150 mm (5.9 in) retainer pin can be inserted.
3. To reload the tension on the parking brake cable, follow the release procedure in reverse.
-
Make sure the cable tension is reloaded slowly.
