Navigator 4WD V8-5.4L (2010)
11. Position the Y-pipe and install the 4 (2 RH and 2 LH) nuts.
-
Tighten to 40 Nm (30 lb-ft).
12. Remove the Engine Support Bar, Support Hook and Engine Support Bracket.
13. Install the starter. For additional information, refer to Starting System.
14. If servicing the engine support insulator on a 4WD vehicle, install the front driveshaft. For additional information, refer to Drive/Propeller Shafts,
Bearings and Joints.
15. Install the generator. For additional information, refer to Charging System.
16. Install the cooling fan. For additional information, refer to Cooling System &/or Engine Block Heater.
17. Install the TB. For additional information, refer to Fuel Charging and Controls - 5.4L (3V).
18. Connect the battery ground cable. For additional information, refer to Battery.