Navigator 4WD V8-5.4L (2010)
Control Arm: Service and Repair
Front Suspension
Lower Arm
Lower Arm
Removal
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result
in major service expense. New parts must be installed with the same part numbers or equivalent parts, if replacement is necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
1. Measure the distance from the center of the hub to the lip of the fender with the vehicle in a level, static ground position (curb height).
2. Remove the wheel knuckle. For additional information, refer to Wheel Knuckle See: Front Steering Knuckle/Service and Repair.
3. NOTE: Use the hex-holding feature to prevent the stud from turning while removing the nut.
Remove and discard the stabilizer bar link lower nut.