Navigator 4WD V8-5.4L (2010)
4. Lock the selector lever cable lock tab.
5. NOTE: Install a new heat shield if it is loose on the cable.
If equipped, install the heat shield.
6. Install the selector lever cable and rubber grommet.
Expedition
7. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever
cable into the bracket and listen for the selector lever cable to click into place. Pull back on the selector lever cable to make sure that it is locked
into the bracket.
NOTE: The selector lever bezel has been removed from art for clarity. Do not remove the selector lever bezel.
Connect the selector lever cable onto the selector lever.
1. Connect the selector lever cable onto the selector lever housing.
-
Listen for the audible click.
-
Pull back on the selector lever cable to make sure that it is securely installed.
2. Connect the selector lever cable onto the selector lever arm.
-
Listen for the audible click.
-
Pull back on the selector lever cable to make sure that it is securely installed.
