Navigator 4WD V8-5.4L (2010)
Windshield: Service and Repair
Glass Reseal - Windshield
Glass Reseal - Windshield
1. Remove the cowl panel grille.
2. Remove the A-pillar trim panels.
3. If equipped, remove the overhead console. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
4. If equipped, remove the rain sensor. For additional information, refer to Wiper and Washer Systems.
5. If equipped, remove the roof opening panel trim.
6. Remove the interior rear view mirror. For additional information, refer to Mirrors.
7. Remove the sun visors.
8. Partially lower the front portion of the headliner near the windshield upper opening and block with a suitable material.
9. Clean the edge formed by the existing urethane adhesive and the glass on the inside at the top and sides, and outside on the bottom of the
windshield with glass cleaner.
10. Cut the urethane adhesive applicator tip to specification.
11. NOTE: Use either a high-ratio electric or battery-operated caulk gun that will apply the urethane adhesive with less effort and a continuous bead.
Apply a bead of urethane adhesive to the cleaned area.
12. NOTE: Make sure that all gaps in the urethane adhesive are smoothed into one continuous bead.
Backfill the urethane application and clean the excess.
13. NOTE: The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks.
After the urethane adhesive has cured, check the windshield seal for air or water leaks through the urethane adhesive bead and add urethane
adhesive as necessary.
14. Reposition the headliner.
15. Install the sun visors.
16. Install the interior rear view mirror. For additional information, refer to Mirrors.
17. If equipped, install the roof opening panel trim.
