Navigator 4WD V8-5.4L DOHC VIN A (2000)
Wheel Speed Sensor: Service and Repair
Sensor, Rear
Removal
1. Raise and support vehicle.
2. Note: Clean off dirt and debris that may have collected around the rear anti-lock brake sensor before removal.
Remove the rear anti-lock brake sensor.
1. Disconnect the rear anti-lock brake sensor electrical connector.
2. Remove the bolt.
3. Remove the rear anti-lock brake sensor.
Installation
1. Note: Thoroughly clean the mounting surface.
Note: Inspect the anti-lock brake sensor O-ring for damage; lightly lubricate the O-ring with SAE-75W-140 High Performance Rear Axle
Lubricant FITZ-19580-B or equivalent meeting Ford specification WSL-M2C192-A.
To install, reverse the removal procedure.