Navigator 4WD V8-5.4L DOHC VIN R (2001)
1. CAUTION: To prevent interference with rear disc brake caliper operation, install only the correct caliper bolt.
NOTE: Make sure the stainless steel shoe slippers are correctly positioned. Install new slippers if worn or damaged.
NOTE: When installed, the locator notch on the brake pads will be located at the upper end of the rear disc brake caliper.
Install the rear disc brake caliper.
2. Install the rear wheel brake hose.
^
Use new copper washers; connect the brake hose and install the caliper flow bolt.
3. Bleed the rear disc brake caliper.
4. WARNING: Always remove any corrosion, dirt or foreign material present on the mounting surfaces of the wheel, wheel hub, or brake
disc. Any foreign material on the wheel mounting surfaces can cause the wheel nuts to loosen and come off while the vehicle is in motion,
causing loss of control.
Clean the wheel hub mounting surface.
5. NOTE: If equipped with air suspension, reactivate the system by turning on the air suspension switch.
Install the wheel and tire assembly.
6. Verify correct brake operation.
Caliper Disassembly and Assembly
