Navigator 4WD V8-5.4L DOHC VIN R (2001)
11. Cut the 3/8 inch evaporator inlet line near the A/C line grommet.
12. Cut the 3/8 inch evaporator inlet line near the rear crossmember.
13. Cut the 3/8 inch evaporator inlet line forward of the rear wheel opening.
14. Cut the 3/8 inch evaporator inlet line between the frame and the muffler heat shield.
15. Remove and discard the cut sections.
INSTALLATION
NOTE:
^
Lay out new lines in vehicle position to assist in installation.
^
Refer to the Multiple-Piece Auxiliary A/C Heater Line Kit.