Navigator 4WD V8-5.4L DOHC VIN R (2001)
Front Steering Knuckle: Service and Repair
Removal
1. Remove the wheel hub.
2. Make preliminary adjustment references.
1
Make an alignment mark on the torsion bar and the torsion bar crossmember support.
2
Measure and record the length.
3. Relieve the torsion bar tension.
1
Remove the torsion bar adjuster bolt.
2
Install the Torsion Bar Tool with the Torsion Bar Tool Adapters in the B slots on the Torsion Bar Tool.
3
Tighten the Torsion Bar Tool until the torsion bar adjuster lifts off of the adjuster nut.
4
Remove the torsion bar adjuster nut.
5
Remove the Torsion Bar Tool.
6
Remove the torsion bar adjuster.
