Navigator 4WD V8-5.4L DOHC VIN R (2001)
2. Slide the small opening end of the slip-yoke boot on the driveshaft stub shaft, as far as it will travel.
3. Using the special tool, crimp the driveshaft slip-yoke boot clamp.
4. Install the driveshaft slip-yoke on the driveshaft.
1
Pull the slip-yoke boot toward the driveshaft.
Lubricate the driveshaft splines with approximately 10 grams (0.24 oz.) of lubricant.
^
Use Premium Long-Life Grease XG-1-C or equivalent meeting Ford specification ESA-M1C75-B.
2
Position the new large slip-yoke boot clamp.
3
Align the blind splines, and install the driveshaft slip-yoke on the driveshaft.
5. Set the driveshaft assembled length to specification.