Navigator 4WD V8-5.4L DOHC VIN R (2001)
19. NOTE: Tighten the through-bolt until the tool is in the closed position.
Using the special tool, install the two boot clamps.
20. Install the halfshaft in the vehicle.
Removal and Installation
Halfshaft
Special Tools
Special Tool(s)
Removal and Installation
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This
can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so can result in unexpected inflation
or deflation of the air springs, which can result in shifting of the vehicle during these operations.
Raise and support the vehicle.
2. Remove the front wheel and tire assembly.
3. Remove the fastener.
1
Remove and discard the cotter pin.
2
Remove the retainer.
3
Remove the nut