Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
6. Lower the headliner enough to gain access to the rear antenna cable connection.
7. Disconnect the rear lead-in cable from the antenna cable.
8. Remove the antenna rear lead-in cable bolt.
9. NOTE: The antenna is an integral part of the wiring harness and can not be replaced separately from the harness. Cut the ends off of the old
antenna cable and tape the remainder to the wiring harness to prevent noise.
Remove the ground plate and remove the antenna cable ends.
10. NOTE: When installing the new cable, tape or wire tie the new cable to the wiring harness to prevent noise.
To install, reverse the removal procedure.