Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
Brake Caliper Removal and Installation
Brake Caliper
Removal and Installation
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so can result in
unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
Remove the wheel and tire assembly.
2. WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally,
drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted or plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it
with water.
Remove the bolt and disconnect the hose.
^
Remove and discard the copper washers.
3. Remove the brake pads.
4. Inspect the rear disc brake caliper for leaks.
^
If leaks are found, disassembly is required.
5. To install, reverse the removal procedure.
