Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
3. Install the crankshaft rear seal retainer plate and the 6 bolts in the sequence shown.
^
Tighten to 10 Nm (89 inch lbs.).
4. Install the 2 crankshaft rear seal retainer plate-to-oil pan bolts and tighten in 2 stages.
^
Stage 1: Tighten to 20 Nm (15 ft. lbs.).
^
Stage 2: Tighten an additional 60 degrees.
5. NOTE: Lubricate the inner lip of the crankshaft rear seal with clean engine oil.
Using the special tools, install the crankshaft rear seal.
6. Using the special tools, install the crankshaft rear oil slinger.