Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
1. Connect a clear waste line to the RH rear disc brake caliper bleeder screw and the other end in a container partially filled with recommended brake
fluid.
2. Have an assistant pump the brake pedal and then hold firm pressure on the brake pedal.
3. Loosen the RH rear disc brake caliper bleeder screw until a stream of brake fluid comes out. Have an assistant maintain pressure on the brake
pedal while tightening the RH rear disc brake caliper bleeder screw.
^
Repeat until clear, bubble-free fluid comes out.
^
Refill the brake master cylinder reservoir as necessary.
4. Tighten the RH rear disc brake caliper bleeder screw.
5. Repeat Steps 1, 2, 3, and 4 for the LH rear disc brake caliper bleeder screw, RH front disc brake caliper bleeder screw, and the LH front disc brake
caliper bleeder screw.
6. NOTE: Go to the Help menu in the diagnostic tool.
Connect the diagnostic tool DCL cable adapter into the vehicle data link connector (DLC) under the dash and follow the diagnostic tool
instructions.
7. Repeat the conventional bleed procedure as outlined in Steps 1 through 5.
8. If the brake pedal feels spongy, repeat the diagnostic tool service bleed procedure.
Gravity
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder reservoir filled
