Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
Power Steering Line/Hose: Service and Repair
Power Steering Pump to Steering Gear Pressure Line
Power Steering Pump to Steering Gear Pressure Line 4x4
Material
Removal and Installation
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power
steering components can result.
NOTE: New O-ring seals must be installed any time the lines are disconnected from the steering gear.
All vehicles
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located near the jack storage area in the rear of the passenger
compartment. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle
during these operations. Failure to follow these instructions may result in personal injury.
Turn the air suspension switch to the OFF position, if equipped.
2. Remove the engine cooling fan.
3. Remove the power steering pump pulley.
4. Disconnect the pressure line-to-pump fitting.
^
Discard the Teflon seal.
^
Allow the fluid to drain into a suitable container.
5. Remove the 2 bolts and the oil drip shield.
