Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
Seat Belt Buckle: Service and Repair
Front Safety Belt Buckle - Center
FRONT SAFETY BELT BUCKLE - CENTER
Torx Bit, Safety Belt Bolt
Special Tool(s)
Removal and Installation
WARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt height
adjusters (if so equipped) child safety seat tether attachments and attaching hardware should be inspected after any collision. All belt
assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in
use during a collision should also be inspected and replaced if either damage or incorrect operation is noted.
1. Remove the safety belt buckle bolt and route the safety belt buckle out of the seat.
2. NOTE:
-
Make sure the safety belt webbing is not twisted prior to installation.
-
Make sure to tighten all nuts and bolts to specification.
To install, reverse the removal procedure.
-
Make sure the safety belt buckle is accessible to the occupant after installation.
3. Check the active restraint system for correct operation.
Rear Safety Belt Buckle - Second Row, 20 Percent Seat
REAR SAFETY BELT BUCKLE - SECOND ROW, 20 PERCENT SEAT
Removal and Installation
WARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt height
adjusters (if so equipped) child safety seat tether attachments and attaching hardware should be inspected after any collision. All belt
assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in
use during a collision should also be inspected and replaced if either damage or incorrect operation is noted.
1. Remove the second row 20 percent seat.