Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
Seat Belt Height Adjuster: Service and Repair
Safety Belt Shoulder Height Adjuster - Second Row
SAFETY BELT SHOULDER HEIGHT ADJUSTER - SECOND ROW
Torx Bit, Safety Belt Bolt
Special Tool(s)
Removal and Installation
WARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt height
adjusters (if so equipped) child safety seat tether attachments and attaching hardware should be inspected after any collision. All belt
assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in
use during a collision should also be inspected and replaced if either damage or incorrect operation is noted.
NOTE: The LH side is shown, the RH side is similar.
1. NOTE: Inspect the shoulder safety belt guide cover for damage. If the shoulder safety belt guide cover is damaged or if it does not remain closed,
install a new shoulder safety belt guide cover.
Remove the second row LH side safety belt guide.
1
Release the retaining tab at each side and open the safety belt guide cover.
2
Remove the nut.
3
Remove the second row LH side safety belt guide.
2. Remove the LH C-pillar trim panel.
1
Separate the weatherstripping along the LH C-pillar trim panel.
2
Remove the bolt cover and bolt.
3
Pull out to release the retainers and remove the LH C-pillar trim panel.