Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
2. Install the safety belt buckle and pretensioner.
1
With the anti-rotation tab aligned, position the safety belt buckle and pretensioner to the seat.
2
Install the nut.
3
Route the safety belt buckle and pretensioner usage detection switch and pretensioner electrical connectors as noted in removal.
3. Reposition the safety belt buckle and pretensioner electrical connectors to the seat cushion frame.
-
Connect the usage detection switch electrical connector.
-
Reposition the pin-type retainer to the safety belt buckle pretensioner electrical connector and install it under the seat.
4. Reposition the seat cushion trim cover over the safety belt buckle and pretensioner and attach the hook-and-loop strip.
5. Attach the seat backrest J-clip to the seat cushion frame.
6. Install the 40 percent front seat on the side with the affected safety belt buckle and pretensioner.
7. Repower the SRS.