Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
Rear Knuckle Alignment Link: Service and Repair
TOE LINK
REMOVAL AND INSTALLATION
WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle.
This can be accomplished by turning off the air suspension switch located in the LH rear quarter trim panel. Failure to do so can result in
unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
1. If equipped, turn the air suspension switch to the OFF position.
2. Remove the wheel and tire assembly.
3. NOTE: Use the hex holding feature to prevent the stud from turning while removing the nut.
Remove the nut and separate the toe link from the wheel knuckle.
4. Remove the nut and the toe link.
5. To install, reverse the removal procedure.
6. Check and, if necessary, adjust the rear toe.