Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
Stabilizer Link: Service and Repair
Stabilizer Bar and Link
Removal and Installation
WARNING: The electrical power to the air suspension system, must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the LH rear quarter trim panel. Failure to do so can
result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
1. If equipped, turn the air suspension switch to the OFF position.
2. Remove the wheel and tire assemblies.
3. NOTE: Use the hex holding feature to prevent the stud from turning while removing the nut.
Remove the two nuts.
^
Discard the nuts.
4. NOTE: Use the hex holding feature to prevent the stud from turning while removing the nut.
Remove the two nuts and the stabilizer bar links.
^
Discard the nuts.
5. Remove the four nuts, brackets and the stabilizer bar.
6. NOTE: Inspect and, if necessary, install new bushings.
To install, reverse the removal procedure.
