Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
3
Remove the reverse band servo spring.
Installation
NOTE: This is not an ordinary installation procedure and does not compensate for band wear.
1. NOTE: Lubricate the reverse piston seal to facilitate assembly and prevent damage to the seal.
Install the reverse servo return spring and piston.
^
Do not install the piston cover.
2. Install the special tool and tighten the band apply bolt.
3. Attach the special tool to the transmission.
^
Position the indicator stem on the flat portion of the reverse servo piston and zero the dial indicator.