Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
4. Install the indicator back in the filler tube until it is fully seated, then remove the indicator.
The fluid level should be within the normal operating temperature range.
High Fluid Level
A fluid level that is too high may cause the fluid to become aerated due to the churning action of the rotating internal parts. This will cause erratic
control pressure, foaming, loss of fluid from the vent tube and Possible transmission malfunction and/or damage. If an overfill reading is indicated
drain and refill the transmission.
Low Fluid Level
A low fluid level could result in poor transmission engagement, slipping, malfunction and/or damage. This could also indicate a leak in one of the
transmission seals or gaskets.
Adding Fluid
CAUTION: The use of any type of transmission fluid other than specified could result in transmission malfunction and/or damage.
If fluid needs to be added, add fluid in 0.25L (1/2 pint) increments through the filler tube. Do not overfill the fluid. For fluid type, refer to the General
Specifications chart.
Fluid Condition Check
1. Check the fluid level.
2. Observe the color and the odor. The color under normal circumstances should be dark reddish, not brown or black or have a burnt odor.
3. Hold the fluid level indicator over a white facial tissue and allow the fluid to drip onto the facial tissue and examine the stain.
4. If evidence of solid material is found, the transmission fluid pan should be removed for further inspection.
5. If the stain is a foamy pink color, this may indicate coolant in the transmission. The engine cooling system should also be inspected at this time.
6. If fluid contamination or transmission failure is confirmed by the sediment in the bottom of the fluid pan, the transmission must be disassembled
and completely cleaned. This includes the torque converter, coolers and cooler lines.
7. Carry out diagnostic checks and adjustments; refer to Diagnosis By Symptom.
