Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
1. NOTE: When installing the new seal, make sure that the drain hole in the seal is in the 6 o'clock position.
Using the special tool, install a new extension housing seal.
2. NOTE: The output shaft and the driveshaft are a balanced assembly.
Install the driveshaft.
^
Align all the index marks and position the driveshaft on the transmission.
^
Install the driveshaft.
3. NOTE: To maintain driveshaft balance, install the driveshaft yoke and flange in the original position that was marked during removal.
Install the 4 retaining bolts.
4. Check the level of the transmission fluid, add clean automatic transmission fluid as necessary.
Manual Control Lever Shaft and Seal
Manual Control Lever Shaft and Seal