Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
7. Connect the main transmission electrical harness by pushing it in and twisting the outer shell to lock it in place.
8. Remove the fluid fill plug.
^
The fill plug is located on the RH rear side of the case near the transmission electrical connector.
9. CAUTION: The use of any other transmission fluid than specified can result in the transmission failing to operate correctly or transmission
failure.
Fill the transmission.
^
Add 4.7 liters (5 quarts) of clean automatic transmission fluid to the transmission through the fluid fill hole. Stop when the fluid runs out of
the bottom of the hole.
10. Install the fluid fill plug.
11. Start the engine. Move the transmission range selector lever through all the gear ranges, checking for engagements.
12. With the engine idling (600 - 750 rpm) in PARK and the transmission temperature at 30°C - 50°C (86°F - 122°F), check and adjust the
