Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
Material
1. Remove the halfshaft assembly.
2. Using the special tools, remove the stub shaft pilot bearing seal.
3. Using the special tools, remove the stub shaft pilot bearing.
1
Firmly engage the tangs of the special tool on the stub shaft pilot bearing.
2
Remove the bearing.
4. Inspect the seal journal for rust, nicks and scratches. Polish the seal journal surface with fine crocus cloth, if necessary.
5. Lubricate the new stub shaft pilot bearing with axle lubricant.
6. CAUTION: Installation of the stub shaft pilot bearing or stub shaft oil seal without the correct tools can result in early bearing or seal failure. If
the stub shaft pilot bearing becomes cocked in the bore during installation, remove it and install a new one.
Place the stub shaft pilot bearing onto the special tools.
