Navigator 4WD V8-5.4L SOHC VIN L (1998)
Power Steering Pump: Service and Repair
Power Steering Pump Pulley
REMOVAL
1. Prepare the vehicle for power steering pump pulley removal.
(1) Remove the fan and shroud.
(2) Remove the drive belt.
2. Remove the power steering pump pulley using the Power Steering Pump Pulley Remover.
INSTALLATION
1. Install the power steering pump pulley.
-
Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, replace the pulley. If there is no paint or one paint
mark, use a paint pencil to mark the web area of the pulley near the hub.
-
Use the Power Steering Pump Pulley Replacer.
CAUTION: Replacement of the power steering pump pulley is necessary after being removed and installed two times.
2. Restore the vehicle to operating condition.
(1) Install the drive belt.
(2) Install the fan and shroud.
