Navigator 4WD V8-5.4L SOHC VIN L (1998)
1. NOTE: The rear case bushing has one lube groove. The front case bushing has three lube grooves.
Place the (A) rear case bushing onto the (B) Rear Case Bushing Replacer.
2. Place the other portion of the (A) Rear Case Bushing Replacer and the (B) 1 27-mm (5-inch) Threaded Drawbar through the case and into the front
case bushing.
3. CAUTION: Make sure the bushing and tool are centered in the bore.
Place the (A) rear case bushing with the (B) Rear Case Bushing Replacer over the (C) 127-mm (5-inch) Threaded Drawbar and into the case.
Install the (D) washer and the (E) nut hand-tight.
4. Hold the (A) drawbar with a 1/2-inch wrench while turning the (B) nut with a 1-1/8-inch wrench until the (C) rear case bushing is fully seated.
Remove the tools.