Navigator 4WD V8-5.4L SOHC VIN L (1998)
Fluid - A/T: Service and Repair
NOTE: MERCON Automatic Transmission Fluid is being replaced by MERCON V as a service fluid.
REMOVAL
1. If equipped, turn the air suspension switch OFF.
2. Disconnect the battery ground cable.
3. Raise the vehicle on a hoist.
4. Disconnect the harness connector at the digital Transmission Range (TR) sensor.
5. CAUTION: When replacing the transmission fluid and filter and seal assembly; the torque converter should be drained transmission cooler,
cooler lines, and cooler bypass valve must be thoroughly flushed to remove any contamination.
NOTE: Do not discard the gasket unless damaged. This is a reusable gasket.
Remove the transmission fluid pan and gasket.
1
Loosen, but do not remove the bolts.
2
Remove the front and side bolts.
3
Lower the front of the fluid pan and allow the fluid to drain.
4
Remove the remaining fluid pan bolts and the fluid pan.