Navigator 4WD V8-5.4L SOHC VIN L (1998)
5. CAUTION: Do not reuse the orifice cup plug or spring and stop assembly. Failure to replace these parts may cause repeat repairs. Make sure the
old rubber stop is removed (it may become separated from the spring assembly).
CAUTION: Use care not to damage any machined surfaces of the stator support.
Remove and discard the (A) orifice cup plug and the (B) spring and stop assembly. Make sure the old (C) rubber stop is removed. Clean and
inspect the bore, making sure it is clean of any debris.
6. NOTE: Obtain Pump Banding Tool and one 10-mm bolt prior to removing the pump body bolts. This tool is needed to align the pump with the
control body assembly during reassembly.
Separate the pump control body from the pump body.
1
Remove the 11 bolts.
2
Support the pump body.
3
Remove the (A) bolt and separate the (B) pump body from the (C) pump control body.
7. CAUTION: Do not remove any of the remaining cup plugs unless directed to do so in other steps. Do not remove the stator support from the
control body. This can distort the surface of the control body.
