Navigator 4WD V8-5.4L SOHC VIN L (1998)
14. Remove the bearing caps and bolts.
-
To establish differential bearing preload, increase both left and right shim sizes by the specification shown in the illustration.
-
Use a shim driver to ensure the differential bearing shims are fully seated and the assembly turns freely.
15. CAUTION: Mark the position of the bearing caps as arrows may not be visible. The bearing caps must be installed in their identical locations and
positions.
Install the bearing caps and bearing cap bolts.
16. Use the Dial Indicator with Bracketry to recheck the backlash.
-
For further adjustments.
17. Install the axle shafts.
18. Install the driveshaft.
19. Install the axle housing cover and refill the rear axle with specified lubricant.
Conventional