Navigator 4WD V8-5.4L SOHC VIN L (1998)
3. Install the front axle hub.
1
Install the front axle hub nut.
2
Install the retainer.
3
Install the cotter pin.
4. Install the front suspension arm upper ball joint castle nut.
1
Position the front wheel knuckle.
2
Install the upper ball joint castle nut.
3
Install a new cotter pin.
NOTE: If equipped with air suspension, reactivate the system by turning on the air suspension switch.
5. Install the tire and wheel assembly.
1
Position the tire and wheel assembly.
2
Install the lug nuts and lower the vehicle.
3
Tighten in the lug nuts in sequence.
4
Install the wheel cover.
Disassembly and Assembly